Computer Clicking Noise Troubleshooting
Difficulty: Moderately Complicated
1. Turn off the particular computer, and open it to reach the components. Most computer cases have screws down the edge of the back panel that support the sides in place; you will be able to see the back edges in the side panels underneath the particular screws. Remove these screws, and slide the remaining side panel backwards to reveal the within of the computer.
Some computer cases open by removing top panel, usually by a clasp around the bottom. If your computer opens with the front, slide the still left side panel forward in order to reveal the components.
Some cases could have different procedures for admittance. Consult the manual for the computer or case.
2. Turn on the computer and isolate the reason for the clicking. Lincoln Specter of PC World recommends with a cardboard tube, such together from an empty document towel roll. Hold one end belonging to the tube up to you ear, and place the opposite near the component people suspect of clicking. Let down and unplug the computer ahead of handling any components.
3. Reseat the cables using a clicking hard drive to make sure that they are seated securely.
4. Replace the hard disk cables. Plug in in addition to reboot the computer.
5. Remove and replace the clicking hard disk. By the time the computer does not boot from a disk drive, it is likely unusable as well as any unsaved data misplaced.
6. Re-seat the RAM stays and all connectors about the motherboard. Check whether that processor fan is going properly. Listen carefully for the order or rhythm while in the clicking that comes in the motherboard. Most motherboards use a beep code used to help indicate problems, and with some motherboards it equates as a click. System board manufacturers use different requirements; some popular brands' beep codes are usually in the Resources section.
7. Disconnect a clicking CD-ROM travel, and restart. Clicking while in the CD-ROM drive indicates malfunction, and may impede the particular boot up process.
8-10. Disconnect and replace a new clicking power supply; a failing power supply will probably be unable to provide the electricity that a computer needs as a way to boot up. Clicking may indicate which the fan inside the strength supply is failing.
Subscribe to:
Post Comments (Atom)
Post a Comment